SCARABEO 125 - 200
•
Drain off the oil into the collecting con-
tainer by pumping it out with the stem.
Overhaul
Wheel holder stem
•
Check the sliding surface for scorings and/or scratches. These scorings can be eliminated
by rubbing them with wet sandpaper (dowel 1).
•
If the scorings are deep, replace the stem.
•
Use a dial gauge to check that the stem bending is below the limit value.
•
If over the value, replace the stem.
CAUTION
A BENT STEM SHOULD NEVER BE STRAIGHTENED BECAUSE ITS STRUCTURE WOULD BE
WEAKENED AND USING THE VEHICLE MAY BECOME DANGEROUS.
Characteristic
Bending limit:
0.2 mm
Sleeve
•
Check that there are no damages and/
or cracks; otherwise, replace it.
•
If there are signs of excessive wear or
damage, replace the affected compo-
nent.
Replace the following components with new ones:
- O-ring gasket on the cap «1»;
Suspensions
SUSP - 149