APRILIA SCARABEO 125 Service Manual page 84

Engine
Removing the wheel axle bearings
•
Warm up the crankcase.
•
Remove the bearing using the specific
extractor.
Removing the driven pulley shaft bearing
•
Remove the driven pulley shaft.
•
Remove the oil seal using a screwdriv-
er; working from inside the bearing and
being careful not to damage the hous-
ing, make it come out on the belt trans-
mission side.
•
Remove the bearing using the specific
extractor.
Inspecting the hub shaft
- Check the three shafts for wear or distortions on
the toothed surfaces, on the bearing housings and
the oil seal positions.
- In faults are found, replace the damaged parts.
Inspecting the hub cover
- Check that the coupling surfaces are not dented or distorted.
- Check the capacity of both the bearings and the wheel oil seal.
- In case of faults, replace the damaged parts.
ENG - 84
SCARABEO 125 - 200