Table of Contents
Advertisement
6.8.1
Control channel C1 directly
Designation
Channel function
Control channel C1 directly
Debounce time
Long button push starting at
Double-click additional function
Time for double-click
Direct control: This parameter is only available at I1 and only for the dimming function.
23
Applies here to I1 and for I2 if used.
24
Applies here to I1 and for I2 if used.
25
Applies here to I1 and for I2 if used.
26
Flush-mounted dimming actuator DU 1
Values
Switch..
Button..
Dimming..
Blinds..
Window contact..
yes
23
No
30 ms, 50 ms, 80 ms
24
100 ms, 200 ms,
1 s, 5 s, 10 s
300 ms, 400 ms
25
500 ms, 600 ms
700 ms, 800 ms
900 ms, 1 s
no
yes
300 ms, 400 ms
26
500 ms, 600 ms
700 ms, 800 ms
900 ms, 1 s
Description
A direct control of the dimming
actuator (C1) is only possible
with the dimming function.
I1 is used exclusively as an
input for dimming actuator
channel C1.
I1 is connected to C1 internally
and has no communication
objects.
I2 will be integrated
automatically, if required.
I1 is used purely as a KNX binary
input.
There is no internal connection to
the switch actuator.
In order to avoid disruptive
switching due to bouncing of the
contact connected to the input,
the new status of the input is
only accepted after a delay time.
Larger values (≥ 1 s) can be used
as a switch-on delay
Serves to clearly differentiate
between long and short button
push.
If the button is pressed for at
least as long as the set time,
then a long button push will be
registered.
No double-click function
The double-click parameter page
is shown.
Serves to differentiate between a
double-click and 2 single clicks.
Time period in which the second
click must begin, in order to
recognise a double-click.
Advertisement
Table of Contents
