Table of Contents
Advertisement
6.7.4
Input I1, I2: Blinds function
Designation
Activate channel
Channel function
Control channel C1 directly
Debounce time
Activate block function
Block telegram
Long button push starting at
Double-click additional function
Time for double-click
Flush-mounted dimming actuator DU 1
Values
no
yes
Switch..
Button..
Dimming..
Blinds..
Window contact..
No
30 ms, 50 ms, 80 ms
100
ms,
200
ms,
1 s, 5 s, 10 s
no
yes
Block with 1 (standard)
Block with 0
300
ms,
400
ms
500
ms,
600
ms
700 ms, 800 ms
900 ms, 1 s
no
yes
300
ms,
400
ms
500
ms,
600
ms
700 ms, 800 ms
900 ms, 1 s
Description
Use input?
The input controls a blind
actuator.
I1 is used purely as a KNX binary
input.
There is no internal connection to
the switch actuator.
In order to avoid disruptive
switching due to bouncing of the
contact connected to the input,
the new status of the input is
only accepted after a delay time.
Larger values (≥ 1 s) can be used
as a switch-on delay.
No block function.
Show block function parameter
page.
0 = cancel block
1 = block
0 = block
1 = cancel block
Serves to clearly differentiate
between long and short button
push.
If the button is pressed for at
least as long as the set time,
then a long button push will be
registered.
No double-click function
The double-click parameter page
is shown.
Serves to differentiate between a
double-click and 2 single clicks.
Time period in which the second
click must begin, in order to
recognise a double-click.
Advertisement
Table of Contents
