Table of Contents
Advertisement
6.7.1.1
Each of the 2 objects can be configured individually on its own parameter page.
Designation
Object type
Send if
input = 1
Telegram
Send if
input = 0
Telegram
Send cyclically
Response after
restoration of the bus
supply
14
Response when the
block is set
DU 1 RF: Response after download or mains restoration
14
Flush-mounted dimming actuator DU 1
Switch objects 1, 2
Values
Switching (1 bit)
Priority (2 bit)
Value 0-255
Percentage value (1 byte)
no
yes
With object type = switching 1
bit
ON
OFF
INVERT
With object type = priority 2 bit
inactive
ON
OFF
With object type = value 0-255
0-255
With object type = percentage
value
1 byte
0-100%
no
yes
See above: Same object type as
Send if input = 1
no
yes, always
only if input = 1
only if input = 0
none
update (immediately)
update (after 5 s)
update (after 10 s)
update (after 15 s)
Ignore block
no response
Description
Telegram type for this object.
Send if voltage is present at the
input?
Send switch-on command
Send switch-off command
Invert current state (ON-OFF-ON
etc.)
Function
Priority inactive
(no control)
Priority ON
(control: enable, on)
Priority OFF
(control: disable, off)
Any value between 0 and 255
can be sent.
Any percentage value between 0
and 100% can be sent.
Send if no voltage is present at
the input?
When should cyclical sending
take place?
The cycle time is set on the main
parameter page of the channel.
Do not send.
Send update telegram
immediately or with delay.
The block function is ineffective
with this telegram.
Do not respond when the block is
set.
Value
0 (00
)
bin
3 (11
)
bin
2 (10
)
bin
Advertisement
Table of Contents
