Figure 70. Power adapter installation
1. Install the enclosure into rack if necessary.
2. Refer to Configuration Installation Guide for the DIN rail configuration and wall-mounted configuration
installation details if necessary.
3. Reconnect power cords and all external cables.
4. Turn on the server (see "Turn on the server" on page 32).
Remove a power adapter
Use this information to remove a power adapter.
Before you remove a power adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Remove the enclosure from the rack if necessary.
To remove a power adapter, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
.
Chapter 5
Hardware replacement procedures
85