Table of Contents
Advertisement
Figure 57. Intrusion switch cable removal
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install the intrusion switch cable
Use this information to install the intrusion switch cable.
Before you install the intrusion switch cable, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
To install the intrusion switch cable, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Insert the intrusion switch cable through the hole on the carrier.
.
Chapter 5
Hardware replacement procedures
73
Advertisement
Table of Contents
