Table of Contents
Advertisement
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install an M.2 drive on an M.2 data adapter
Use this information to install M.2 drive on an M.2 data adapter.
Before you install an M.2 drive, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
To install an M.2 drive, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Figure 61. M.2 drive on an M.2 data adapter installation
Note: In the process of installation, carefully proceed the steps to prevent the drives from dropping.
Step 1.
Insert the retainer into the slot and push it forward to firmly seat it into the slot.
Step 2.
Insert the M.2 drive on the bottom into the slot with an angle as shown.
Step 3.
Rotate the M.2 drive on the bottom upward and hold it to against the adapter.
Step 4.
Install the screw to secure the M.2 drive to the adapter.
Step 5.
Insert the M.2 drive on the top into the slot with an angle as shown.
Step 6.
Rotate the M.2 drive on the top downward and hold it to against the adapter.
Step 7.
Install the screw to secure the M.2 drive to the adapter.
After you install an M.2 drive, complete the following steps:
ThinkAgile MX Certified Node Small FactorThinkAgile MX1021User Guide
76
Advertisement
Table of Contents
