Table of Contents
Advertisement
Figure 55. Fan installation
Table 21. Fan installation
Round pin
1
Step 1.
Align the fan with the slot in the fan cage; then, place the fan into the slot. Make sure the fan cable
goes in the cable slot, under the round pin as shown.
Step 2.
Connect the fan cable to the connector by pressing it down until it clicks.
After you install a fan, complete the following steps:
1. Reinstall the air baffle if it was removed (see "Install the air baffle" on page 53).
2. Install the node if needed (see "Install a compute node" on page 58).
3. Reconnect power cords and all external cables.
Intrusion switch cable replacement
Follow this procedure to remove and install the intrusion switch cable.
Remove the intrusion switch cable
Use this information to remove the intrusion switch cable.
Before you remove the intrusion switch cable, complete the following steps:
1. Read the following sections to ensure that you work safely.
Fan cable
2
.
Chapter 5
Hardware replacement procedures
71
Advertisement
Table of Contents
