Table of Contents
Advertisement
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Remove the node from the enclosure if needed (see "Remove a compute node" on page 55).
4. Remove the air baffle (see "Remove the air baffle" on page 52).
To remove a fan, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Figure 54. Fan removal
Step 1.
Press and hold the fan cable latch.
Step 2.
Disconnect the cable from the connector.
Step 3.
Push the fan up from the bottom of the node and lift it out of the fan cage.
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install a fan
Use this information to install a fan.
To avoid possible danger, read and follow the following safety information.
.
Chapter 5
Hardware replacement procedures
69
Advertisement
Table of Contents
