Figure 58. Intrusion switch cable installation
Step 1.
Lower the intrusion switch carrier into the chassis and press the intrusion switch carrier down until
it is securely seated.
Step 2.
Fasten the two screws.
Step 3.
Connect the cable to the connector and press it down until it clicks.
Figure 59. Intrusion switch installation
After you install the intrusion switch, complete the following steps:
1. Install the node if needed (see "Install a compute node" on page 58).
2. Reconnect power cords and all external cables.
M.2 drive on an M.2 data adapter replacement
Use the following information to remove and install an M.2 drive on an M.2 data adapter.
ThinkAgile MX Certified Node Small FactorThinkAgile MX1021User Guide
74