Table of Contents
Advertisement
Figure 25. M.2 data adapter installation
After you install a M.2 data adapter, complete the following steps:
1. Install the PCIe riser assembly (see "Install the PCIe riser assembly" on page 50 for instructions).
2. Install the node if needed (see "Install a compute node" on page 58).
3. Reconnect power cords and all external cables.
Remove the M.2 boot adapter
Use this information to remove the M.2 boot adapter.
Before you remove the M.2 boot adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Remove the node from the enclosure if needed (see "Remove a compute node" on page 55).
4. Remove the intrusion switch (see "Remove the intrusion switch cable" on page 71).
To remove the M.2 boot adapter, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1.
Grasp the M.2 boot adapter at both ends and pull it straight up to remove it from the system board.
.
Chapter 5
Hardware replacement procedures
47
Advertisement
Table of Contents
