Table of Contents
Advertisement
Figure 27. M.2 boot adapter installation
After you install the M.2 boot adapter, complete the following steps:
1. Install the intrusion switch (see "Install the intrusion switch cable" on page 73).
2. Install the node if needed (see "Install a compute node" on page 58).
3. Reconnect power cords and all external cables.
Remove the PCIe adapter
Use this information to remove the PCIe adapter.
To avoid possible danger, read and follow the following safety statement.
• S012
CAUTION:
Hot surface nearby.
Before you remove the PCIe adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Remove the node from the enclosure if needed (see "Remove a compute node" on page 55).
4. Remove the PCIe riser assembly (see "Remove the PCIe riser assembly" on page 77 for instructions).
To remove the PCIe adapter, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
.
Chapter 5
Hardware replacement procedures
49
Advertisement
Table of Contents
