Versions; Checking Versions - Omron NJ Series Startup Manual

Versions

Hardware revisions and unit versions are used to manage the hardware and software in NJ-series
Units and EtherCAT slaves. The hardware revision or unit version is updated each time there is a
change in hardware or software specifications. Even when two Units or EtherCAT slaves have the
same model number, they will have functional or performance differences if they have different hard-
ware revisions or unit versions.

Checking Versions

You can check versions on the ID information indications or with the Sysmac Studio.
Checking Unit Versions on ID Information Indications
The unit version is given on the ID information indication on the side of the product.
 NJ501-R£00
The ID information on the NJ-series NJ501-R300 CPU Unit is shown below.
Robot Control Function
Note The hardware revision is not displayed for the Unit that the hardware revision is in blank.
NJ-series Robot Integrated System Startup Guide (O049)
ID information indication
Unit model
NJ501 -
RC Ver.1.
Module version
PORT1 MAC ADDRESS:
PORT2 MAC ADDRESS:
Lot No. DDMYY
Unit version
R300 Ver.1.
xxxx
Lot number Serial number
Versions
Hardware revision
HW Rev.
MAC address
19