Install The Log Set - Vermont Castings Intrepid INDVR Series Installation & Operating Manual

Install the Log Set

Remove the logs from their packaging and inspect each piece
for damage. DO NOT INSTALL DAMAGED LOGS.
!
Before installation, inspect ember bed burner for damage.
Do not use ember bed if damaged or cracked. NOTE:
Small, shallow surface cracks are acceptable.
1. Install the rear log by matching the notch on the bottom
left of the log on the raised notch on back left side of the
ember bed. Cutout on bottom right side is clearance for
pilot assembly. (Figure 58) Gently push right side of log
back until it contacts thermopile on pilot assembly.
2. Place the left front log on the pin locator on ember bed.
Position the log over the air inlet hole and on notched out
portion of ember bed. (Figure 60)
3. Place front right log on ember bed by mating notch on
bottom of log with raised notch on ember bed. Position
over the air inlet hole and on notched out portion of ember
bed. (Figure 60)
4. Install top log by mating hole on bottom of log with locat-
ing pin on top right side of rear log. (Figure 61) Position
log so it is angled down toward the area where the front
two logs meet.
Figure 58
Lg493
Rear log
6/07
29
CAUTION
Rear Log
Raised
Notch
Pin
Figure 59
LG497
SDDVT ember bed
6/07
Left
Log
Figure 60
Left
Log
Ember Bed
Figure 61
LG499
Intrepid logs
7/07
Pilot
Assembly
LG498 Top Log
Back Log
Intrepid left/right logs
7/07
Right Log
Raised
Notch
Right
Log
20012761