Table of Contents
Advertisement
Pilot Assembly
Figure 73 - Pilot Assembly location.
• Remove pilot orifice with Allen wrench. (Figure 75)
• Install the conversion orifice.
• Reinstall pilot hood. Be sure to align hood with index
tab.
Pilot Hood
Pilot
Bracket
Figure 74 - Remove pilot hood.
Index Tab
Snap Ring
Figure 75 - Remove pilot orifice.
Pilot type 2
• Loosen pilot hood turning counterclockwise using
a 7/16" wrench. (Figure 76) NOTE: You may use
penetrating oil to prevent pilot hood threads from
seizing up.
CO106a
DV360/580
• Remove pilot orifice with needlenose pliers. (Figure
Gas Conversion
77) NOTE: Use a wrench to hold pilot tube in place
Pilot2
while removing the orifice.
1/28/00 djt
• Install the conversion orifice.
• Reinstall pilot hood and tighten until mark on pilot
hood aligns with mark on pilot bracket.
35
ST935
SDDVT
pilot location
6/07
Allen Wrench
CO105a
gas conversion
Pilot
1/28/00 djt
Index
Marks
Pilot Bracket
Figure 76 - Remove pilot hood. (Your pilot may have a different
appearance.)
Figure 77 - Remove pilot orifice.
Burner Orifice Conversion
1. Remove three (3) 3/8" nuts on bottom side of burner
pan. (Figure 78)
2. Carefully remove ember bed by tilting the right side up
and lifting out toward the right side of the unit. (Figure
79)
Bottom View
Remove Nuts
Figure 78 - Remove three (3) nuts securing ember bed in place.
3. Remove injector orifice from left burner bracket with a
1/2" wrench.
4. Install conversion orifice. (Refer to Table 3)
5. The air shutter is factory set according to table on Page
7 and should not need adjustment. The air shutter
opening may be verified by measuring as shown in
Figure 80.
Pilot Hood
CO105
Pilot
Orifice
Gas Conversion
Pilot
2/15/99 djt
CO106a
Gas Conversion
Pilot (Vermont)
7/19/99 djt
Remove Nut
ST918
remove nuts
7/07
20012761
Advertisement
Table of Contents
