Table of Contents
Advertisement
Your Intrepid Gas Heater will provide years of service with
minimal upkeep. The following procedures will help ensure
that your stove continues to function properly.
Annual System Inspection:
Have the entire heater and venting system inspected annually
by a qualified gas technician. Replace any worn or broken
parts.
Logset and Burner
Cleaning and Inspection:
Cleanliness is critical to the proper function of the heater.
The logset and burner must all be kept free of dust and
unobstructed by debris. Inspect these areas before each use
and clean as necessary.
1. Turn the burner OFF and let the heater cool completely
before cleaning.
2. Lift the Stove Front up and then swing the bottom out to
disengage it from the heater shell. (Figure 81)
3. Carefully remove the glass and frame assembly and
place it out of the way on a flat, padded surface such as
a counter protected by a towel.
4. Carefully inspect the Logs for damage. Contact your local
dealer if any damage is evident. DO NOT OPERATE THE
HEATER WITH DAMAGED LOGS.
5. Use a soft bristled brush to sweep dust or debris from the
Logs, Pilot and Burner. Use care as the logs are fragile
and susceptible to damage.
6. Replace the glass panel and frame assembly.
7. Replace the Stove Front.
Care of Cast Iron:
An occasional dusting with a dry rag will help keep the painted
surfaces looking new. Use high-temperature stove paints,
available through your local dealer, to touch-up areas as
needed. Clean areas to be painted with a wire brush and be
sure to cover the logs, burner and valve assembly, glass and
frame assembly. Apply the paint sparingly; two light coats of
paint will give better results than a single heavy coat.
Clean porcelain enamel surfaces with a soft, damp cloth.
Do not use abrasive cleaning agents. If necessary, use only
a cleaning agent formulated especially for use on porcelain
enamel surfaces.
!
TURN THE PILOT OFF BEFORE PAINTING. ALLOW
THE HEATER TO COOL COMPLETELY BEFORE
PAINTING.
37
Maintenance
CAUTION
!
Cleaning the Glass:
WARNING: Let the glass cool completely before
attempting to clean.
It will be necessary to clean the glass periodically. During
start-up, condensation, which is normal, forms on the inside of
the glass and causes lint, dust and other airborne particles to
cling to the glass surface. Also initial paint curing may deposit
a slight film on the glass. It is therefore recommended that
the glass be cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend gas
fireplace glass cleaner). After that the glass should be cleaned
two or three times during each heating season depending on
the circumstances present.
Clean glass after first two weeks of operation.
Glass Replacement
Replace glass only with Vermont Castings Group approved
parts. Refer to Page 40 for Replacement Parts. Refer to
Figure 82 and previous instructions for removal of the
damaged glass frame.
Figure 81 - Remove the stove front.
WARNING
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
ST967a
Remove Front
7/07
20012761
Advertisement
Table of Contents
