Install The Log Set - Vermont Castings INDVRCBSB Installation And Operating Instructions Manual

Install the Log Set

Remove the logs from their packaging and inspect each
piece for damage. DO NOT INSTALL DAMAGED LOGS.
CAUTION: Before installation, inspect ember bed burner
for damage. Do not use ember bed if damaged or cracked.
NOTE: Small, shallow surface cracks are acceptable.
1. Install the rear log by matching the notch on the bottom
left of the log on the raised notch on back left side of the
ember bed. Cutout on bottom right side is clearance for
pilot assembly. (Fig. 58) Gently push right side of log
back until it contacts thermopile on pilot assembly.
Figure 58
Lg493
2. Place the left front log on the pin locator on ember bed.
Rear log
Position the log over the air inlet hole and on notched
6/07
out portion of ember bed. (Fig. 60)
3. Place front right log on ember bed by mating notch on
bottom of log with raised notch on ember bed. Position
over the air inlet hole and on notched out portion of
ember bed. (Fig. 60)
Raised Notch
Pin
Figure 59
LG497
SDDVT ember bed
6/07
20306761
Rear Log
Pilot Assembly
Raised
Notch
Intrepid® Direct Vent - Rear Vent Gas Heater
Left Log
Figure 60
LG498
4. Install top log by mating hole on bottom of log with Intrepid left/right logs
7/07
locating pin on top right side of rear log. (Fig. 61) Posi-
tion log so it is angled down toward the area where the
front two logs meet.
Left Log
Ember Bed
Figure 61
LG499
Intrepid logs
7/07
Top Log
Back Log
Right Log
Right
Log
29