Skoda Octavia III 2013 Service Manual page 93

– Unplug connector -2- at air mass meter -G70-
– Detach bleeder hose -1- and air guide hose -5-.
– Release the spring strap clip -3- with pliers for spring strap
clips and remove the air guide hose from the pipe.
– Release screw -4- and remove air filter housing.
– Raise vehicle.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Position the catch pan under the gearbox.
– Lower the vehicle.
– Unscrew oil filter housing -1- from gearbox.
– Before removing, the oil filter must be slightly inclined.
So that the oil can flow out of the oil filter back into the gearbox.
Note
Always replace O-ring -2-.
– Remove filter -3-.
– Moisten O-ring -2- with gear oil.
– Moisten the O-ring in the suction belt -arrow- downwards.
– Insert filter with suction belt -arrow- downwards into the gear‐
box.
– Install filter housing and tighten to 20 Nm.
– Install air mass meter -G70- , plug in electrical plug connec‐
tions, secure the bleeder hose with clamps ⇒ Corresponding
engine; Rep. gr. 24 where necessary ⇒ Corresponding en‐
gine; Rep. gr. 21 .
Change gear oil, check oil level
– Raise vehicle.
– Remove protection plate -A- at the bottom of the gearbox
-arrows-; if applicable.
• The catch pan is under the gearbox.
DANGER!
♦ Wear safety goggles.
♦ Wear protective gloves.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
89
4. Gearbox