Skoda Octavia III 2013 Service Manual page 153

The water spray should strike the windscreen in a cone-shaped
pattern.
If the nozzle setting does not comply with the manufacturing set‐
ting, or if it was replaced:
– Move the adjuster upwards or downwards -arrows- and while
doing so adjust the spray nozzles of the windscreen washer
system in such a way that the correct injection jet is reached.
Note
If the spray flows out unevenly or insufficiently, replace the spray
nozzle (repair measure).
Windscreen wiper arms: Check rest position, adjust where nec‐
essary
– Check the position of the wiper blades so that these blades
are aligned with the markings on the windscreen.
Note
Set the end position of the windscreen wiper arms ⇒ Electrical
♦
System; Rep. gr. 92 .
♦ The tolerance between wiper blade and marking at the wind‐
screen is ± 2 mm.
– If necessary slacken fixing nuts, detach windscreen wiper
arms and insert again so that the wiper blades are aligned with
the markings.
Windscreen wiper arm of rear window wiper system: Check rest
position, adjust where necessary
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
149
7. Body