Skoda Octavia III 2013 Service Manual page 58

Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
3.8.1 Replace oil filter with replacement oil fil‐
ter for petrol engines
Remove replacement oil filter
– Remove the noise insulation.
The 4 cylinder petrol engine 1.2 l TSI and 1.6 MPI
– Loosen oil filter -arrow- with oil filter wrench - 3417- .
The 4 cylinder petrol engine 1.4 TSI
– Loosen oil filter -arrow- with oil filter wrench - 3417- .
Continued for all vehicles
– Unscrew oil filter.
Install new replacement oil filter
– Clean sealing surface at engine.
– Lightly moisten the rubber seal of the new filter with oil.
– Screw in the new filter and tighten it with the oil filter wrench -
3417- .
Tightening torque
Oil filter
– Drain engine oil ⇒ page 47
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
– Install the noise insulation.
3.8.2 Replace oil filter with replacement oil fil‐
ter insert for petrol engines
Remove replacement oil filter element
– Remove engine cover.
– Loosen oil filter cover -arrow- with socket insert SW 32 and
partially unscrew it.
– Wait a few minutes so that the oil flows out of the oil filter
housing oil filter insert and back into the engine.
54
.
Nm
20