Skoda Octavia III 2013 Service Manual page 59

– Remove oil filter cover -1- completely.
Note
Make sure no engine oil runs onto the cylinder block. If necessary,
use a cloth. If necessary, use a cloth.
– Remove filter insert -3-.
– Drain engine oil ⇒ page 47
Install new replacement oil filter element
– Moisten the new O-ring -2- with engine oil and insert in the nut
on the oil filter cover -1-.
– Replace filter insert -3-, oil drum -4- and O-ring -5- and -6-.
– Screw in the oil filter cover -arrow- with the socket insert SW
32 and tighten to tightening torque.
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
– Install the engine cover.
Tightening torque
Oil filter cover
3.8.3 Replace oil filter insert for diesel engines
Remove replacement oil filter element
– Remove the noise insulation.
– Disconnect the plug -1- from the trailing pump.
– Unclip the generator cable -2- from the clip -3- and raise it in
-direction of arrow-.
.
Nm
25
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
55