Note
The lit warning light for exhaust system in the dash panel insert
♦
indicates faults in the exhaust-relevant systems. These faults
(including sporadic ones) are stored in event memory.
Resolve all identified faults, including sporadic faults, when
♦
reading the event memory before the exhaust emissions test
(repair procedure)
⇒ "6.9 Connect diagnostic unit and query event memory",
page 130
.
Test conditions for vehicles without EOBD
•
Faultless function of the engine without extraordinary inequal‐
ities in the engine running behaviour.
•
Engine temperature, min. 80 ℃
•
Air conditioning switched off
•
Event memory (01- Engine electronics) is not read
Connect the test equipment
– Connect the tester in compliance with the operating instruc‐
tions.
– Start the engine, allow it to warm up to the operating temper‐
ature (the best way is to drive it) and allow it to run in idle.
– Perform the exhaust-emission analysis.
Note
All tubes and plug connections, which had been removed or
♦
disconnected for the test and adjustment, must be correctly
re-inserted or connected.
The exhaust gas probe must be fully inserted into the exhaust
♦
tailpipe (do not insert into the suction tube)!
Test Values for Exhaust-Emission Analysis on Diesel Engines
The values are valid for the date of issuing of this workshop man‐
ual.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
8. Exhaust-emission analysis
161