Skoda Octavia III 2013 Service Manual page 143

Hide thumbs Also See for Octavia III 2013:
Table of Contents

Advertisement

The unladen weight is the weight of the vehicle with full fuel tank
(at least 90%) including the weight of all the operational equip‐
ment elements (e.g. spare wheel, tool kit, jack etc.).
If the fuel tank is not filled up to at least 90%, the load must be set
as follows:
– Determine the fuel volume in the fuel tank on the fuel gauge
display.
– Load vehicle with corresponding weight via the fuel tank ac‐
cording to the following table:
Fuel gauge
Weight (kg)
Reserve
35
1/4
30
1/2
18
3/4
7
Fuel tank full 0
Note
Use as weight e.g. plastic tanks filled with water or canisters.
1 liter of water = 1 kg.
When fitting the weight onto the rear seat pay special attention
so that the seat upholsteries are not dirty or damaged.
The vehicle must have rolled a few metres or have been de‐
pressed a few times at the front and rear to allow the springs to
settle.
The vehicle and the headlight beam setting device must be on
a level surface.
Align the vehicle and the headlight beam setting device in ac‐
cordance with the instructions of the device manufacturer.
Check the control system of vehicles equipped with headlight
beam control by repeatedly turning the thumbwheel in the
dash panel. Then turn the thumbwheel to initial position.
For vehicles equipped with adaptive headlights (cornering
light) perform first of all the basic setting
Set the inclination value.
Basic setting
This setting is carried out on the vehicle while it is standing on its
wheels using the diagnostic unit -VAS- together with the corre‐
sponding diagnostic cable ⇒ Vehicle diagnostic tester.
– Switch on ignition and connect diagnostic unit ⇒ Vehicle diag‐
nostic tester.
– Switch on low beam light.
– On the diagnostic device, select: "Targeted functions" → "Ško‐
da" → "Octavia 2013►" → "Engine type" and further → "Body
Work" and further → "Electrical System" and further →" 01 Self-
diagnosable systems"..
– Then choose "55 cornering light J-745" followed by "Basic set‐
ting".
– Initiate test and proceed by referring to the read-out on the
display of the diagnostic unit.
Octavia III 2013 ➤ , Octavia III 2014 ➤
⇒ page 139
.
Maintenance - Edition 12.2014
6. Electrical System
139

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Octavia iii 2014

Table of Contents