Table of Contents
Advertisement
Figure 26
Transport Lock Positions
1. Transport lock
2. L
position—the
OCK
mower deck locks into
the transport position.
g032377
3. U
position—the
NLOCK
mower deck is not locked
into the transport position
Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving
the clevis pin into different hole locations.
1.
Move the transport lock to the L
2.
Push on the deck-lift pedal with your foot and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inch) cutting-height
position); refer to
3.
To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
27).
4.
Insert the pin into a hole that corresponds to the
desired height of cut
5.
Push on the deck-lift pedal, pull back on the
transport lock, and slowly lower the mower deck.
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the neutral-locked
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
28,
Figure
29, and
27
position.
OCK
Figure
27.
(Figure
(Figure
27).
Figure 27
3. Transport lock
Figure
30.
g029840
Figure
Advertisement
Table of Contents
