Table of Contents
Advertisement
Figure 28
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 29
1. Anti-scalp roller
2. Bushing
Figure 30
1. Anti-scalp roller
2. Spacer
3. Bushing
g029955
4. Flange nut
5. Bolt
g029956
3. Flange nut
4. Bolt
g029957
4. Flange nut
5. Bolt
Adjusting the Flow Baffle
Cam Locks
This procedure is applicable only to machines with
the flow baffle locks. Certain models will have nuts
and bolts in-place of the flow baffle locks and can be
adjusted the same.
The mower discharge flow can be adjusted for
different types of mowing conditions. Position the cam
locks and baffle to give the best quality of cut.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the neutral-locked
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
To adjust the cam locks, swing the lever up to
loosen the cam lock
4.
Adjust the baffle and cam locks in the slots to
the desired discharge flow.
5.
Swing the lever back over to tighten the baffle
and cam locks
6.
If the cam locks do not lock the baffle into place
or it is too tight, loosen the lever and then rotate
the cam lock. Adjust the cam lock until you
achieve the desired locking pressure.
28
(Figure
31).
(Figure
31).
Figure 31
g027727
Advertisement
Table of Contents
