Table of Contents
Advertisement
Storage
Cleaning and Storage
1.
Disengage the power take off (blade-control
switch (PTO), set the parking brake, and turn the
ignition key to the off position. Remove the key.
2.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside of the engine cylinder
head fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
engine, hydraulic pumps, and motors.
3.
Check the brake; refer to
(page
53).
4.
Service the air cleaner; refer to
Cleaner (page
39).
5.
Grease the machine; refer to
Lubrication (page
6.
Change the crankcase oil; refer to
Engine Oil (page
7.
Check the tire pressure; refer to
Tire Pressure (page
8.
Change the hydraulic filters; refer to
the Hydraulic System (page
9.
Charge the battery; refer to
(page
47).
10.
Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
11.
Check the condition of the blades; refer to
Servicing the Cutting Blades (page
12.
For storage over 30 days, prepare the machine
as follows:
A.
Add a petroleum-based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol-based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
Brake Maintenance
Servicing the Air
Greasing and
36).
Servicing the
40).
Checking the
49).
Servicing
59).
Charging the Battery
63).
B.
Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C.
Stop the engine, allow it to cool, and drain
the fuel tank; refer to
Tank (page
D.
Restart the engine and run it until it stops.
E.
Dispose of fuel properly. Recycle as per
local codes.
Important:
stabilizer/conditioned fuel over
90 days.
13.
Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
14.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
15.
Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it out of reach of children or
other unauthorized users. Cover the machine to
protect it and keep it clean.
68
Servicing the Fuel
45).
Do not store
Advertisement
Table of Contents
