Table of Contents
Advertisement
Figure 24
Driving Backward
1.
Move the levers to the center, unlocked position.
2.
To go backward, slowly pull the motion-control
levers rearward
(Figure
Figure 25
g008952
25).
g008953
Stopping the Machine
To stop the machine, move the traction control levers
to neutral and move to locked position, disengage the
power take off (blade-control switch (PTO), and turn
the ignition key to off.
Engage the parking brake when you leave the
machine; refer to
Engaging the Parking Brake (page
21). Remove the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.
Adjusting the Height of Cut
Using the Transport Lock
The transport lock has a L
position and is used with the deck-lift pedal. Refer
to
Figure
26.
26
position and an U
OCK
NLOCK
Advertisement
Table of Contents
