Specifications - Toro Z Master 75990 Operator's Manual

Choke
Use the choke to start a cold engine. Pull the choke
knob up to engage it.
Blade-Control Switch (PTO)
The blade-control switch (PTO) is used to engage
the electric clutch and drive the mower blades. Pull
the switch up to engage the blades and release. To
disengage the blades, push the blade-control switch
(PTO) down or move a motion-control lever into the
neutral-lock position.
Ignition Switch
This switch is used to start the mower engine and has
three positions: S
TART
Motion-Control Levers
The motion-control levers are used to drive the
machine forward, reverse, and turn either direction.
Neutral-Lock Position
The neutral-lock position is used with the
safety-interlock system to engage and to determine
neutral position.
Fuel-Shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
, R and O .
UN FF

Specifications

Note:
Specifications and design are subject to
change without notice.
Width:
Without deck
Deflector up
Deflector down
Length:
Roll bar up
Roll bar down
Height:
Roll bar up
179.1 cm (70.5 inches)
Weight:
Model
75990
16
60 inch Deck
134.6 cm (53.0 inches)
156.8 cm (61.7 inches)
192.2 cm (75.7 inches)
60 inch Deck
211.1 cm (83.1 inches)
215.4 cm (84.8 inches)
Roll bar—down
118.9 cm (46.8 inches)
Weight
585 kg (1,290 lb)