Table of Contents
Advertisement
Charging the Battery
WARNING
Charging the battery produces gases that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1.
Charge battery for 10 to 15 minutes at 25 to 30
A, or 30 minutes at 10 A.
2.
When the battery is fully charged, unplug
the charger from the electrical outlet; then
disconnect the charger leads from the battery
posts
(Figure
60).
3.
Install the battery in the machine and connect
the battery cables, refer to
(page
46).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 60
1. Positive battery post
2. Negative battery post
Installing the Battery
g000960
3. Red (+) charger lead
4. Black (-) charger lead
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows check the
component/circuit for a malfunction or short.
1.
The fuses are located on right hand console
next to the seat
2.
To replace the fuses, pull out on the fuse to
remove it.
3.
Install a new fuse
1. Optional accesory—15 A
2. Charge—25 A
3. PTO—10 A
47
(Figure
61).
(Figure
61).
Figure 61
4. Main—25 A
5. Console
g008966
Advertisement
Table of Contents
