Greasing The Pump-Belt-Idler Arm; Greasing The Caster-Wheel Bearings - Toro Z Master 75990 Operator's Manual

Greasing the
Pump-Belt-Idler Arm
Service Interval: Yearly—Grease the pump-belt-idler
arm.
Grease the pump-belt-idler arm
Figure 45
(Figure 45).
g009030
37
Greasing the Caster-Wheel
Bearings
Service Interval: Yearly—Grease the front caster
pivots (more often in dirty or dusty
conditions).
Yearly—Repack the front caster-wheel bearings
(more often in dirty or dusty conditions).
1. Remove the dust cap and adjust the caster
pivots.
Note:
Keep the dust cap off until greasing is
done.
2. Remove the hex plug.
3. Thread a grease fitting into the hole.
4. Pump grease into the fitting until it oozes out
around the top bearing.
5. Remove the grease fitting in the hole.
6. Install the hex plug and dust cap
Figure 46
7. Grease the caster-wheel bearings
(Figure 46).
g009187
(Figure 46).