Removing Components - Juniper T4000 Quick Start Manual

T4000 Core Router Quick Start
14

Removing Components

NOTE: For complete instructions on removing router components, see the
T4000 Core Router Hardware Guide
Before lifting the router, you must remove the following components (see the location
of the components in Figure 5 on page 15
Power supplies
Cable management system
SIBs
Control boards
SONET Clock Generators (SCGs)
Fan trays
Flexible PIC Concentrators (FPCs)
To remove the components from the router:
Slide each component out of the chassis evenly so that it does not become stuck or
1.
damaged.
Label each component as you remove it so you can reinstall it in the correct location.
2.
Immediately store each removed component in an electrostatic bag.
3.
Do not stack removed components. Lay each one on a flat surface.
4.
.
and Figure 6 on page 16):
Copyright © 2012, Juniper Networks, Inc.