Henny Penny FlexFusion FPE-615 Installation Manual page 29

The unit is fastened by means of two floor plates, as indicated in the
drawing.
Floor without steam barrier
In the case of floors without a steam barrier, the floor plates are
bolted to the floor using the bolts provided.
Prerequisite Floor capable of accommodating the weight of the unit
Floor must be clean and suitable for the manner fastening
Unit set up and aligned in accordance with the planning drawing
1. Align the floor plates in position 1-1 or 2-2 on the unit leg as
shown in the drawing and mark the fastening holes on the floor.
2. Mark the position of all unit legs on the floor.
3. Using suitable lifting equipment, move the unit so that the holes
can be drilled in the floor.
4. Drill holes with a diameter matching that of the anchor sufficiently
deep in the floor.
5. Carefully place the unit in the installation position.
6. Using the anchors and fastening screws provided, screw the floor
plates to the floor.
7. Ensure that a tight seal against the floor has been reestablished
after the fastening screws are installed.
8. Complete the start-up operation report.
Floor with steam barrier
In the case of floors with a steam barrier, the floor plates are not
screwed to the floor but fastened with the enclosed adhesive.
Prerequisite Floor capable of accommodating the weight of the unit
Floor must be clean and suitable for the manner fastening
Unit set up and aligned in accordance with the planning drawing
1. Align the floor plates in position 1-1 or 2-2 on the unit leg as
shown in the drawing and mark the floor.
2. Using the adhesive provided, fasten the floor plates to the floor.
3. Complete the start-up operation report.
Follow the manufacturer's instructions regarding the adhesive.
Apply the adhesive in accordance with the manufacturer's
instructions.
Observe the drying time specified in the manufacturer's
instructions.
Installation instructions
Installing the unit
29