Honda CB160 Shop Manual page 84

80
fig. 4. 92 Rear brake· coupling
Fig. 4. 93 Chain tension
fig. 4. 94 Rear brake pedal play
4. FRAME
4. Fix the spring to the rear brake shoe, ancl fit the
anchor pin, and cam to the shoe ; install these parts
to the brake pedal.
Fit the 20 X
25
cotter pin,
anchor pin setting washer and brake arm, and fix
them with the 6 X22 hex bolt. (Refer to Fig.
4.
92)
5.
The panel should be coupled to the rear wheel,
and it should be contained in the frame and be
tightened by the rear axle. However, the chain
should be fitted, prior to this and sef by the clip ;
tension of the chain should be adjusted by the
drive chain adjuster.
(NOTE)
When chain tension is adjusted by the chain ad-
juster, left chain adjuster and that of the rear fork
should be set at the same position. In addition,
slack of the chain ranges from 1 0 to 20 mm. (.39
to .78nl (Refer to Fig. 4. 93)
6. Install the rear brake limit arm to the rear brake
panel.
7. Install the rear brake wire to the brake arm.
Set the rear brake panel on its side and adjust
rear brake play, (Refer to fig.
4.
94)
(NOTE)
Rear brake pedal play ranges from 20 to 30 mm.
1.78
to 1.1
JllJ