Honda CB160 Shop Manual page 26

22
3. ENGINE
Fig. 3. 48 Setting operation of starter clutch roller
spring
Fig. 3. 49 Removing the starting sprocket set plate
Fig. 3. 51 Clutch adiuster
If.
Disassembly and installation of clutch
1. Following Section 2.3 B, the AC generator rotor
is separated from the left crankcase cover.
2. As the starter clutch is installed ot the bock of
the AC generator rotor by using three 6 X 20 pan
screws, it can be seporoted by removing the screws.
3. When instollotion is being performed, attention
should be directed to the following points.
Smooth roller operation.
Starter clutch side plate and guide.
Weak clutch roller spring (replace}.
Ill.
Disassembly and installation of starter
sprocket
l. After separation of the AC generator and the
left crankcase following the previous section, the
starting chain is disconnected at the joint section.
2. By removing the starting sprocket set plate (6 X
12 screws) coupled in the lower crankcase, the
sprocket can be separated from the crankshaft.
(Refer to Fig. 3. 49)
3. The starting motor sprocket is coupled only by
serration and can be extracted quite easily. (Refer
to Fig.
3. 50)
(CAUTION)
The joint clip slot of the starting chain should face
opposite the direction of rotation.
D. Clutch adjuster and neutral switch rotor
I.
Operation of clutch adjuster
For transmitting operation of the clutch cable to
the clutch through the clutch rod, the clutch adjuster
pushes the clutch rod and indicates relationship in
direct start, transmission gear shifting, and stop. That
is, adjustment of the clutch is generally made at the
clutch adjuster adjustment ; affects the vehicle perfor-
mance. (Refer to
Fig. 3.51)