Honda CB160 Shop Manual page 80

76
Fig.
4.
77 Insertion of bearing
Fig.
4.
78 Angle of gear box installation
Fig.
4.
79 Front brake wire adjuster
Fig.
4.
BO Play of
f
rant brake lever
4. FR AME
2. Grease the 6302 R ball bearing and the inside
of the front wheel hub and insert the spacing
collar. Drive in the 6302 R ball bearing. (Refer
to Fig.
4.
77)
(CAUTION)
As the 6302 R ball bearing provides the dust
seal, insure that correct use of the outside and
inside exists.
3. Tighten the front wheel bearing retainer.
4. Hook the spring to the front brake shoe and
install the two anchor pins and brake cams. Fit
the unit to the front brake panel and tighten with
the anchor pin mounting washer and 2 X 25 cotter
pin.
5. Couple the panel to the front wheel and the
gear box to the bearing retainer side. Secure
them by the front wheel axle to the front fork.
(CAUTION)
The gear box joint section should be in line
with
the axles of the front and rear wheels. If not,
due to excessive bend, the speedometer cable may
break. (Refer to Fig. 4. 78)
6. Install the front brake limit arm on the front brake
panel.
7. Connect the speedometer cable to the gear box.
8. Connect the front brake cable to the brake arm
and adjust the play. For adjustment, loosen the
nut (al ; if the adjuster (bl is turned clockwise, the
play increases and vice versa. The designated
play range~ from 30
{l.
l 7nl
to 40 mm
{l
.56,,l.
(Refer to Fig. 4. 79 and 4. 80)