Honda CB160 Shop Manual page 79

4. 12 FRONT WHEEL
Standard value
I
Correction limit
Outside
14.957
to
14.984
mml
diameter
{.598'
to 599
11
)
Bend
Below
0.01
I
{.0004
11
)
3. Measurement of the clearance in the axial and
radial directions of the 6302 R ball bearings.
Standard value Correction limit
Axial clearance
Radial clearance
4. Measurement of brake shoe spring.
Standard value Corr1;>ction limit
Tension
8
kg at 64 mm
(17.6 lb
@ 2.56ul
Free length
55
mm
(2.2
11
)
5. Measurement of the outside diameter and thick-
ness of the front brake shoe.
I
Standard value
Correction limit
Outside
170
mm
(6.8.l
diameter·
Thickness
6. Measurement of thickness of the front brake cam.
Standard value Correction limit
Thickness
7. Inspect and tighten any loose spokes.
8. Air leaks of the tube should be checked by sub-
merging the tube in water.
9.
For tire wear or puncture, not only the outside
but also the inside should be checked.
·o.
Assembly
1.
The tube can be easily inserted by putting
it
inside the tire and applying a small amount of air.
Insert into the bead unit in the rim. (Refer to Fig.
4.74)
(CAUTION)
(al When the tire is on the rim, apply air to 1 /3
the designated pressure and lightly strike around
the tire with a wooden wallet in order to pre-
vent the tube from being pinched. (Refer to
Fig.
4.
75)
(bl The valve stem of the tube should be placed
pointing toward the axle. If not, air leakage
occurs. (Refer to Fig. 4. 76)
fig. 4. 7 4 Installing tire
fig.
4. 75
Tapping tire circumfecence lightly
Fig.
4.
76 Angle of valve stem
75