Table of Contents
Advertisement
6. I
MAINTENANCE
(NOTE)
If the grease ·c;annot enter the fitting, fitting is
wrong and should be replaced.
Grease the front and rear axle bearings.
Front and rear wheel bearings should be greased
every 5000 km. (3100 mil
(l)
Tools required for greasing bearings.
{Refer to
Fig. 6. 45)
(2)
Dismount front and rear wheels, and remove the
bearings.
(31
Remove old grease and wash bearings with
gasoline.
(4)
Thoroughly grease the balls, put some grease in
the hubs, and replace the bearings.
(Refer to Fig.
6. 46)
(4)
Fiber grease should be used.
4.
Oiling the Drive Chain
The chain should be oiled
during
the monthly
di;:ljustment and after every 5000 km. (3100 mil
a.
Tools for chain lubrication.
(Refer to Fig.
6.47)
b.
Unlink the drive chain.
c.
Wash with gasoline.
d.
After the grease has been warmed, immerse
the chain in the grease.
e.
Take the chain out of the grease and wipe
off the surplus.
Reinstall.
f.
Gear oil may be used, but chain grease is
preferable.
F.
Tightening Parts
1.
Critical Connections
Over long periods of operation, some nuts and
bolts will become loose due to constant shock and
vibration.
These should be tightened with a torque
wrench.
a.
Tools required.
(Refer to Fig. 6. 48)
b.
Connections and torque.
(Refer 6. 49 and
6.50)
BEARING
INSERTION TOOL
-
ISO PLIERS
~
AXLE SPANNER
~ - -
fig.
6. 45
Tools required for greasing bearings
fig.
6. 46
After greasing, replace bearings in hub
fig.
6. 47
Tools for chain lubrication
Fig.
6. 48
Tools required
125
Hide quick links:
Advertisement
Table of Contents
