Controller Communications With Nx Bus - Omron NX Series User Manual

1-6-3

Controller Communications with NX Bus

The startup procedures are as follows when the controller is an NX-series CPU Unit.
Overall Procedure
1 Mounting and Hardware Settings
2 Wiring IO-Link Ports
3 IO-Link Master Unit Settings (NX
Unit Settings)
4 Programming
5 Turning ON the Power Supply and
Going Online with the Support
Software
6 Downloading the Controller Con-
figuration Information and the
User Program
7 Parameter Settings for IO-Link De-
vices (as Required)
8 Downloading Parameter Settings
to IO-Link Devices (as Required)
9 Checking the Indicators on the IO-
Link Master Unit and the IO-Link
Devices
10 Checking the Error Status of the
IO-Link Master Unit and the IO-
Link Devices
Procedure Details
Step
1 Mounting and Hardware
Settings
2 Wiring IO-Link Ports
NX/GX-series IO-Link System User's Manual (W570)
Step
User's manual of the IO-Link Master Unit
User's manuals of the IO-Link devices
Section 2 Part Names and Wiring on page 2-1, IO-Link master
user's manuals, and IO-Link device user's manuals
Section 3 Parameter Settings on page 3-1
Section 4 I/O Data on page 4-1
NJ/NX-series CPU Unit Software User's Manual (Cat. No. W501)
Section 6 IO-Link System Communications on page 6-1
Section 4 I/O Data on page 4-1
Section 5 Status and Software Switches Other Than for I/O Data
on page 5-1
NJ/NX-series Instructions Reference Manual (Cat. No. W502)
2-1 Part Names and Functions on page 2-2
6-1 Types and Startup of Communications for IO-Link Systems on
page 6-2
Sysmac Studio Version 1 Operation Manual (Cat. No. W504)
Sysmac Studio Version 1 Operation Manual (Cat. No. W504)
8-4 CX-ConfiguratorFDT Procedures on page 8-24
8-4 CX-ConfiguratorFDT Procedures on page 8-24
10-1-7 Checking for Errors and Troubleshooting with the Indica-
tors on the Front Panel of the IO-Link Master Unit on page 10-13
10-2-3 Sysmac Error Tables on page 10-24
10-2-4 Sysmac Error Descriptions on page 10-30
Description
Connect to the CPU Unit.
---
1 Introduction to IO-Link Systems
Reference
Sysmac Studio operation
---
---
CX-ConfiguratorFDT op-
eration
---
---
1-33
1