Omron NX Series User Manual page 193

Interface
Ethernet I/F
Ethernet -> CS/CJ1
ETN-EIP Unit I/F
NJ/NX Series USB Port
NJ/NX/NY Series Ether-
net Direct I/F
2
Select an interface.
The following gives the procedure to go online with each interface.
l CJ2 USB/Serial Port
Connection example
CJ2-series PLC
1
Right-click Communication DTM in the Network View and select Go online. Or, select the
Communication DTM in the Network View, and then select Go online from the Device Menu.
The Setup Interface Dialog Box is displayed.
2
Set the Port Type, Port, and Baud Rate to suitable values and then click the OK Button to
connect to the CJ2-series PLC. If the connection is successful, the Browse Network Dialog
Box is displayed.
NX/GX-series IO-Link System User's Manual (W570)
8 Applicable Support Software for IO-Link Systems
Connect to the Ethernet port on an EtherNet/IP Unit or an EtherNet/IP Cou-
pler Unit via an Ethernet.
Connect to the Ethernet port on an EtherNet/IP Unit via the Ethernet Unit or
EtherNet/IP Unit mounted on an CS/CJ1-series PLC using an Ethernet in-
terface.
Connect to the Ethernet port on an EtherNet/IP Unit via the USB port on an
NJ/NX-series CPU Unit.
Connect directly from the Ethernet to the built-in EtherNet/IP port. It is not
necessary to set the IP address in the computer.
USB/Serial port
Built-in EtherNet/IP port
Description
NX-series
EtherNet/IP Coupler Unit
NX-EIC202
EtherNet/IP port
8
8-35