Background Color; Pip - Datavideo iCast 10NDI Instruction Manual


Fit

Full

Background Color

You may either enter the RGB values or select a color from the color spectrum to set the screen's
background color. Then fine tune the selected color by dragging the circle cursor on the palette.
Click the color wheel button at the bottom right corner to confirm the selection.

PIP

PIP stands for Picture In Picture. This allows you to be able
to watch two separate inputs at one time. You will have
one large picture with a smaller picture inside of it. As
shown in the diagram below, there are two rows of
channel buttons in PIP mode. Click the top row of channel buttons to change the channel video
shown in the background and you should see the corresponding channel button showing red on the
front panel. Click the bottom row of channel buttons to change the channel video shown in the sub
window and you should see the corresponding channel button showing green on the front panel. If
the same channel video is shown in the background and the sub window, the corresponding channel
button should show red. Buttons of the unselected channel should illuminate white.
R: Red
G: Green
B: Blue
68
H: Hue
S: Saturation
B: Brightness