System; Network Settings; Fw & Fpga Version - Datavideo iCast 10NDI Instruction Manual

Main Menu

4.1 System

In System, you will be allowed to configure the device's network settings, view the device's firmware
version and reset the device to its factory defaults.

Network Settings

The iCast 10NDI can be accessed over an existing TCP/IP LAN type network. In Network Settings, you
will be allowed to gain direct access to the DHCP and Static IP modes.
Enabling DHCP allows the iCast 10NDI to be automatically assigned an IP address upon connection to
the DHCP network. If DHCP is disabled, you will have to manually enter the network settings such as
the static IP address, subnet mask, default gateway (optional), primary DNS (optional) and secondary
DNS (optional).
Detailed network setup instructions can be found in
Search.
FW & FPGA Version
In this option, you will be able to view the firmware version as well as the FPGA version on the 2"
LCD screen as shown below. The firmware upgrade procedure can be found in
5.10 System.
Level 1
Channel 5
Program
23
Level 2
Audio Setting
Record & Stream
Setting Status
Video Source
Audio Source
Audio Setting
Record & Stream
Setting Status
Audio Source
Audio Setting
Record & Stream
Setting Status
Section 5.1 Network Connection and Device
Level 3
Line In
XLR
Main Record
Sub Record
Main Streaming
Sub Streaming
HDMI
IP Stream
NDI
Embed
Line In
XLR
Main Record
Sub Record
Main Streaming
Sub Streaming
Embed
Line In
XLR
Main Record
Sub Record
Main Streaming
Sub Streaming
Appendix 2 or Section