Chapter 4 Osd Menu - Datavideo iCast 10NDI Instruction Manual

Chapter 4
viewed on the OSD menu.
As you turn on the power switch located at the rear of the iCast 10NDI, the following device
information will be displayed on the 2" LCD screen after the device boots up.
iCast 10NDI IP:
Storage Capacity:
PGM Stream:
PGM Layout:
Multiview:
Tap the menu browsing knob up to view the record status or down to view the stream status such as
the disk capacity and the encoder that each video channel is assigned to.
Record Status
Main CH 1 CH 2
Sub CH 1 CH 2
Storage:
To access the OSD menu, simply tap the menu browsing knob right. The OSD menu is summarized in
the table below.
Main Menu
System
Storage Settings
Program CG
OSD Menu
The OSD menu allows the user to access certain device
settings such as the network settings, the program output
frame rate, the program layout, and channel settings. You
will be able to reset the device to its factory defaults and
enable various program CGs. Furthermore, the stream and
record status, firmware version, and disk capacity can be
192.168.001.053
00000 MB Remaining
1080p59/12MB/RTMPS
Quad View
1/2/3/4
REC
CH 3 CH 4 CH 5 PGM
CH 3 CH 4 CH 5 PGM
00000 MB Remaining
Level 1
Network Settings
FW & FPGA Version
Factory Default
Format Type
Storage Capacity
Text
Graphic
Stream Status
Main CH 1 CH 2
Sub CH 1 CH 2
Storage:
Level 2
DHCP
Static IP
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
FW Version
FPGA Version
FAT 32
NTFS
exFAT
ON/OFF
ON/OFF
21
CH 3 CH 4 CH 5 PGM
CH 3 CH 4 CH 5 PGM
00000 MB Remaining
Level 3
Disable
Enable