Effects: Picture In Picture; Effects: Freeze; Border; Background - Datavideo se-500 Instruction Manual

button. You could also select different sources for the left window by pressing 1-4 channel on Main source or
pressing 1-4 channel on Sub source for right window.
6.3

Effects: Picture in Picture

The Picture in Picture effect puts the selected Sub Video Source in a window on the Main
Video Source. Variables for this effect include window size and position. Engage the effect
by pressing the Picture in Picture button and verifying that the LED on the button is lit.
Window size (2 sizes are available); change the window size by pressing the ＋ and － buttons on the left of
the Wipe transitions. (＋ is larger, － is smaller).
There are 9 different positions that are located on the right of the Wipe transition effects. Select from one of
the preset locations by using the buttons. On each corner, use "Right" and "Left" to move the window closer
to the edge or to the center.
This effect may also be used in conjunction with the Border keys (see below).
This is a dual channel effect, and cannot be used with any other transitions or effects.
6.4

Effects: Freeze

This effect freezes the incoming video, as selected on the Main Video Source Bus. There
are no parameters, no variations. Press the button once and the video freezes, press it
again, and it returns to the selected source in full motion.
The Freeze effect is single channel, and can work in conjunction with any transition.
6.5

Border

These controls are used in conjunction with the Picture in Picture Effect and Wipe transition
only, and can only be activated when the Picture in Picture or Wipe control is active.
8 Colors are available for the border: black, blue, magenta, red, green, cyan, yellow and white. See
"Background Color" below. (Wipe only. In PIP mode, the border is set to white color only.)
6.6

Background

While not strictly an effect, these controls are in the same general area, and we thought
you'd look here for any information you might need. These controls select what solid color
the background will be when selected on either the Main or Sub Video bus. There are eight
possible background colors; see below, with the identical LED lights displayed and the indicator on the
preview monitor output. The background colors are: black, blue, magenta, red, green, cyan, yellow, and
white.
Engage this control by pressing the button in this section. The LED's color will correspond with the
background color (except black) to indicate that the controls are active. Repeated presses of the button
select different colors.
26