Chapter 4 Osd Menu; Start; Transition; Type - Datavideo SE-650 Instruction Manual

Chapter 4
The switcher's OSD menu allows the user to perform several configurations of image effects, such as
Picture-in-Picture, keyers, downstream keys, still pictures and etc. The user can also configure the I/O
by selecting the Inputs and Outputs options. In addition, in the setup option, the user is allowed to set
the menu color, size, position and language.
The OSD Menu offers the user basic and advanced modes. The basic mode is generally a condensed
version of the advanced menu mode. The following sub-sections will show you the various options
available in these two modes.

4.1 Start

Start

4.1.1 Transition

The Transition sub-option allows the user to set the MIX effect duration, in frames. If the M/E is set to
a value of 50 then the transition will take effect over a period of 50 frames or roughly 2 seconds.
When the AUTO button is pressed, the transition will take the current M/E value defined by the user
setting.

4.1.2 Type

The SE-650 provides three major types of transition effect, which are MIX, WIPE and Clip. Please note
in addition to selecting the transition effect on the OSD menu, you are also allowed to press the MIX
button, WIPE button or press MIX and WIPE buttons at the same time to enable the respective
transition effects.
• If MIX is selected, set the transition duration in the "Transition" sub-option.
• If WIPE is selected, set the relevant WIPE settings in the "WIPE Effects" sub-option.
• If Clip, also known as the Stinger Effect, is selected, please load the clip in the "User Mems"
sub-option.

4.1.3 Wipe Effects

This sub-option allows the user to select the Wipe Effect and configure the wipe's border softness and
width.
• Wipe – Selection of a WIPE effect from a set of 32 WIPE transition effects.
• Soft – A low value results in a solid edge border and a high value gives a soft diffused border.
• Width – A low value results in a thin border and a high value gives a wide border.
4.1.4 WIPE Border
In this sub-option, the user will be allowed to fine-tune the border color by adjusting the Luma,
Saturation and Hue values.
OSD Menu
Transition
Type
Wipe Effects

Border

Position
Matte
M/E 60
MIX
Wipe 1 Soft
Luma 100% Sat
X 0% Y
Luma 100% Sat
23
0% Width 1%
80% Hue
0%
80% Hue
0
0