Advertisement
Quick Links
ACL800FL-CONV-W - RS485 to TCP/IP
converter - Installation Manual
Description / Operation
The ACL800FL-CONV-W is highly integrated serial to ethernet
converter that enables you to connect any UTC biometric
reader over a local LAN network or over the Internet to your
computer. Configuration of the IP address, dynamic DNS,
TCP/UDP ports can be done from browser or from the ACL800
Wiring
Figure 1: Wiring instructions
LED
1-
TCP Packets
2-
UDP Packets/Reset IP
© 2018 United Technologies Corporation.
Interlogix is part of UTC Climate, Controls & Security, a unit of United Technologies Corporation. All rights reserved.
BioManager software. The software is capable to automatically
search IP addresses of the converters, as well as the serial
numbers of the biometric readers.
The device is already preset for use with the biometric readers.
Specifications
Power Supply:
12VDC, 100 mA
Network interface:
10 BaseT, Half duplex
RS485 interface:
38400 Bps (8 bit data, no parity, 1 stop bit)
"Find Portals" by
ACL800 BioManager
Yes
POE:
No
Security:
Dedicated IP or/and MAC address
DDNS support:
Yes
Visual
LED
TCP/UDP packets
signalization:
DHCP client:
Yes
Default IP address:
192.168.1.100
Reset IP to default:
Yes, by tact switch
PCB size:
32 x 86 mm, 4 fixing holes dia. 3 mm
Housing:
DIN Rail or Wall mount, plastic, size 2 unit
Operating
0 to +40°C, noncondensing
temperature:
Dimension
90 x 37 x 33 mm
P/N 1073494A• REV 00.00 • ISS 4JUL18
Termination resistor
Advertisement
Related Manuals for Interlogix ACL800FL-CONV-W-RS485
Summary of Contents for Interlogix ACL800FL-CONV-W-RS485
- Page 1 Figure 1: Wiring instructions TCP Packets UDP Packets/Reset IP Termination resistor P/N 1073494A• REV 00.00 • ISS 4JUL18 © 2018 United Technologies Corporation. Interlogix is part of UTC Climate, Controls & Security, a unit of United Technologies Corporation. All rights reserved.
- Page 2 Changing the IP address The default IP of the converter is: 192.168.1.100. If you like to change the IP address, follow the instructions bellow. 1. Connect the converter ACL800FL-CONV-W directly to the PC. 2. Change the IP address of the PC, to the same range as the converter’s IP address (192.168.1.XXX) 3.
- Page 3 For more information on warranty disclaimers and product safety information, please check www.firesecurityproducts.com/policy/product- warning/ or scan the following code: Administrator programming For contact information go to: www.interlogix.com Contact or www.firesecurityproducts.com information and To get translations for this and other product manuals manuals go to: www.firesecurityproducts.com...