Table of Contents
Advertisement
3.5
Variator of the roller foot drive
22
Rule:
1. With the correct position of the belt tensioner (1) the distance between
the two cords of the V-belt should be (A) = 1 to 2 mm.
2. If the difference between upper and lower feed is set to zero on the
setting nut (3), the graduation scale on the nut (4) should point exactly
to "O".
5
4
1
3
2
–
Loosen screw (2) and position the belt tensioner roller (1)
according to rule 1. Tighten screw (2).
–
Set the diameter (B) = 34 mm by turning the setting nut (3).
–
Make sure that there is no material displacement between upper
and lower feed. Sew two narrow strips of sewing material of about
30 cm together. If the strips after sewing are vaulted upward or
downward, this indicates a difference between upper and lower
feed. The position of the setting nut (3) must be adjusted
accordingly.
–
After reaching the point of "zero difference", the graduation scale
on the nut (4) must be adjusted. Turn the nut (4) until the third line
of the scale is on the upper edge of the the nut (3). This marks the
zero position.
–
Secure the nut (4) with screw (5).
Advertisement
Table of Contents
