Agilent Technologies 6475 User Manual page 47

4 Basic Operation
Preparing the LC Modules
4 Set up to view real-time parameter values (actuals).
Agilent 6475 Triple Quad LC/MS System User Guide
b Right-click an LC module in the Instrument Status window and select one
of the commands to change any non-method control parameters, if
needed.
c Monitor the baseline and adjust the plot to make sure the column is
equilibrated and the baseline stable. (See
procedure.)
As you prepare for a run and during a run, you want to see the actual values of
the instrument parameters. Do this in the Instrument Status window.
a Right-click the Actuals list to see the Setup command.
step 4 and step 5 in this
47