Scenes; Configuration - Theben DALI gateway S64 KNX User Manual

Scenes

12 Scenes
Scenes can be programmed in the DCA.

12.1 Configuration

You can enter a user-friendly name for each scene in the description field. The name can be up
to 20 characters long. If you do not want a scene to start immediately but would prefer dimming
it up to its final value, you can set the dimming time individually for each scene.
Please remember that the dimming time always refers to the complete value range. A time of
30s therefore means a value change of 100 % within 30 s. If the value within a scene only
changes by 50 %, the change will only take 15 s. To assign a flexible KNX scene to a DALI scene,
the parameter KNX Scene is used. Hereby a flexible assignment can be defined to activate this
scene with another KNX scene (via KNX communication object). The KNX scene numbers 1 to 64
are available.
Select the required scene from the drop down on the left-hand side.
A „tick" means that the scene has already been defined.
Use drag and drop to pull the groups that are part of the scene into the scene window in the
middle.
Manual DALI gateway S64 KNX/S128 KNX 74