Objects For The Time Control Module; Objects For Energy Saving - Theben DALI gateway S64 KNX User Manual

8.2

Objects for the time control module

For each of the up to 16 templates in the colour control module communication objects are
available for activation/deactivation. Please see chapter 13.3 Disabling/enabling. These need to
be enabled under time control in the DCA.
Obj
23
This object activates template 1 in the colour control module. If the value is 1, the template is
active and will be executed according to schedule.
24ff
This object activates template x in the colour control module. If the value is 1, the template is
active and will be executed according to schedule.
8.3

Objects for energy saving

There are 16 energy-saving objects available which can be assigned to groups resp. ECGs in the
corresponding parameters. Therefore, it is possible to activate and deactivate the ECG power
with an additional switching actuator.
55 Energy Saving Object 1
With the appropriate assignment in the parameters, this object is switched off when
associated groups or ECGs are switched off. This allows a separate power supply to be
switched off. If the associated groups or ECGs are controlled again with a value > 0%, this
object is switched on again before.
In this case, a minimum time delay is programmed so that the ECGs are ready for operation
again.
56ff Energy Saving Object x
With the appropriate assignment in the parameters, this object is switched off when
associated groups or ECGs are switched off. This allows a separate power supply to be
switched off. If the associated groups or ECGs are controlled again with a value > 0%, this
object is switched on again before.
In this case, a minimum time delay is programmed so that the ECGs are ready for operation
again.
Manual DALI gateway S64 KNX/S128 KNX
Object name Function
Template 1, Activate Activate/stop
Template x, Activate Activate/stop
ETS communication objects
Type Flags
1 Bit CW
1.010
1 Bit CW
1.010
On / Off 1 Bit
1.001
On / Off 1 Bit
1.001
CRT
CRT
26